KANOMAX 3900 Portable Particle Counter - Manual (Page 33)

3. Display Description and Operation Procedure 26
When a measurement is finished, a measurement
result window will be displayed.
Tap [NEXT] to display MAP again. Then the
instrument waits for the next measurement point to
be selected.
Tap [REMEASURE] to perform a re-measurement.
Tap [PRINT] to print a measurement result.
When all measurements are finished, the
measurement result will be displayed.
You can view the result of a certain LOCATION
POINT by selecting Location.
Tap [CLOSE] to stop a measurement.
Tap [REMEASURE] to perform a measurement
again at the last measurement point.
Tap [PRINT] to print a measurement result at the
last measurement point.
After a whole set of measurement is complete,
button will be displayed.
If you want to view the measurement result again,
tap button to redisplay the measurement result.
Use this button to select
either Total display or
Single display.
(Only applicable for
RAW DATA) Every time you tap this
button, the particle unit
changes in the order of:
p -> p/cf -> p/m³.