KANOMAX 3900 Portable Particle Counter - Manual (Page 70)

3. Display Description and Operation Procedure 63
· PUMP SETTING
In the PUMP setting, set to turn the pump ON all
the time or not.
To turn the pump ON all the time, check the check
box for “PUMP ALWAYS ON”.
After [OK] button is tapped, defined value is saved
to close window.
When [CANCEL] button is tapped, defined value is
canceled.
· REMOTE MODE SETTING
In the REMOTE MODE SETTING, check “START
IN REMOTE MODE” to activate remote mode
automatically when the instrument is turned ON.
Enter remote address in the entry field for ID.
After [OK] button is tapped, defined value is saved
to close window.
When [CANCEL] button is tapped, defined value is
canceled.
If you set to turn the pump ON always, you can
eliminate the PREPARATION time before
sampling.
However, the vane becomes worn or the motor
gets deteriorated as the shaft of the motor may go
off-center while in use.
We recommend you not to turn the pump on all
the time in general use to extend the life of pump.