KANOMAX 3900 Portable Particle Counter - Manual (Page 39)

3. Display Description and Operation Procedure 32
After a measurement at each location is finished, a
measurement result will be displayed.
In [RAW DATA] tab, measurement data will be
displayed.
In [CALC DATA] tab, calculated data of minimum
(MIN), maximum (MAX) and average (AVE) will be
displayed.
Tap [NEXT] to display MAP again and wait for the next
point to be selected.
Tap [REMEASURE] to perform a re-measurement.
Tap [STOP] to stop a measurement.
Tap [PRINT] to print a measurement result.
The color of the measurement point changes from green
to red once a measurement is done.
When all measurements are finished, the measurement
result will be displayed.
You can view the result of a certain LOCATION POINT
by selecting Location.
Tap [EVAL] to display “CLEAN ROOM
EVALUATION” screen.
Tap [REMEASURE] to perform a re-measurement.
Tap [PRINT] to print a measurement result.
Tap [PRINT] to print a measurement result.
By selecting particle size you can change the particle size
of the data to be evaluated. However, the RESULT will
be made based on the particle size selected in the
CONFIG setting.
Tap [Close] to close the window.
<CLEAN ROOM EVALUATION>