KANOMAX 3900 Portable Particle Counter - Manual (Page 65)

3. Display Description and Operation Procedure 58
· SELECT STANDARD
In the SELECT STANDARD window, select a
measurement standard to be applied in the
STANDARD mode.
There are 7 types of standard as follows:
・ ISO14644-1
・ ISO14644-1 SEQUENTIAL SAMPLING
・ FEDERAL STANDARD (m)
・ FEDERAL STANDARD (ft)
・ BRITISH STANDARD
・ EC GMP
・ GB/T 16292-1996
* Refer to 3.5 MODE for the measurement standard.
Select one standard and tap [OK] to activate the
setting.
Change the settings and tap [OK] (Authentication
required). Then a dialog will be displayed saying
“Standard Measurement Setting dialog will open
because standard is changed”. Tap [OK] at the
upper right.
MEASURE SETTING screen will be displayed.
Then configure the settings.
Refer to 3.7.6 STANDARD for setting procedure.
<MEASURE SETTING>