KANOMAX 3900 Portable Particle Counter - Manual (Page 72)

3. Display Description and Operation Procedure 65
· SOUND
In SOUND setting, you can configure the sound volume
and sound type.
Default Sound:
Set the sound for erroneous operation. When this item is unchecked, this sound function will be off.
Tap Sound:
Set the tap sound on the screen. When this item is unchecked, there will be no tap sound.
Alarm Sound:
Set the sound for Alarm. When this item is unchecked, there will be no alarm sound.
Tap [OK] to save the settings and close the window (Authentication required).
Tap [CANCEL] to discard the configured settings, and the previous settings will be applied.
· COMMUNICATION
In the COMMUNICATION SETTING, configure the
setting for Ethernet connection. This setting shall be
configured when connecting the instrument to PC using
remote console or remote mode.
For the HOST NAME, enter the instrument name to be
used when it is connecting by Ethernet.
Be sure not to use the same name as other PC names within
the network or workgroup names when you enter the HOST
NAME.
For IP ADDRESS, check AUTO to acquire IP ADDRESS automatically. If AUTO is unchecked, enter NET
MASK and DEFAULT Gateway.
Tap [OK] to save the settings and to close the window (Authentication required).
Tap [CANCEL] to discard the configured settings, and the previous settings will be applied.
You can use Windows standard WAV format file for
the sound function.
Create a folder called Sound on the CF card. Then copy
the WAV file in the folder. You will be able to select
the file from the list.
* is added to all of the WAV file names on the CF card.