KYORITSU 5000 Instruction Manual - Manual (Page 12)

― 10 ―
Step1: Preparation
1. Connect the clamp sensor to the
instrument firmly with careful attention to
the orientation of the connector.
2. Press the button at least 1 sec. to
power on the instrument. Release the
button when all indications are
displayed on the LCD.
3. Time is displayed on the LCD for 1 sec.
If incorrect time is displayed each time
when the instrument is powered on,
battery for the clock may be exhausted.
In this case, send back the instrument to
your local KEW distributor from where it
was purchased.
4. Can make measurement right after
powering on the instrument. When
(non-connect) is displayed on the LCD,
a sensor is not connected to the
appropriate channel; or the connection
is incorrect.