KYORITSU 5000 Instruction Manual - Manual (Page 20)

― 18 ―
፧
፧
፧
፧
5. State of One-time system is displayed.
on: Recording stops when memory becomes
full.
off: Overwrite the old data, and store the
latest data.
¡ Press the button and proceed to
the next step when not changing the
setting.
¡ To change the setting, press the
button.
Then the indication on the LCD flashes.
Press the
or button to set
the value to the desired one. Then press
the
button to confirm it.
6. Now Setting 1 is complete; "End" is
displayed on the LCD. Press the
button to return to the screen on which
"SEt.1" is displayed.
7. Press the button to get the instrument
ready for a measurement.
LED current indicator
* At the Event/ Max. value/ Capture recording modes, when the preset
current value is exceeded, the corresponding LED for each channel
flashes. The LED flashes each time when the preset current value is
exceeded during a measurement. The LED keep flashing once the
event that exceeds the preset current value occurs during a recording.
Press the
button once to restore the flashing LED.
When the button is pressed, the instrument goes into Menu mode. Then
press the
button. LED flashes when the preset current value
is exceeded again. Press the button to return to the measurement
screen; after the indications disappeared because of Power-save
function. In this case, the LED is turned off temporary . Press the
button and
button again to turn off the LED completely.