KYORITSU 5000 Instruction Manual - Manual (Page 4)

DANGER
¡ Never make measurement on the circuit in which voltage over
AC300V exists.
¡ Do not attempt to make measurement in the presence of flammable
gasses.
Otherwise, the use of the instrument may cause sparking, which
can lead to an explosion.
¡ Transformer jaw tips are designed not to short the circuit under test.
If equipment under test has exposed conductive parts, however,
extra precaution should be taken to minimize the possibility of
shorting.
¡ Never attempt to use the instrument if its surface or your hand is
wet.
¡ Do not exceed the maximum allowable input of any measuring
range.
¡ Never open the Battery cover during a measurement.
¡ Verify proper operation on a known source before use or taking
action as a result of the indication of the device.
WARNING
¡ Never attempt to make measurement if any abnormal conditions,
such as broken case and exposed metal parts are found on the
instrument.
¡ Do not install substitute parts or make any modification to the
instrument.
For repair or re-calibration, return the instrument to your local KEW
distributor from where it was purchased.
¡ Do not try to replace the batteries if the surface of the instrument is
wet.
¡ Make sure to remove the input clamps, and power off the
instrument when opening the Battery cover for battery replacement.
CAUTION
¡ Do not expose the instrument to the direct sun, high temperature
and humidity or dewfall.
¡ Be sure to power off the instrument after use. When the instrument
will not be in use for a long period, place it in storage after removing
the batteries.
¡ Use a cloth dipped in water or neutral detergent for cleaning the
instrument.
Do not use abrasives or solvents.
― 2 ―