KYORITSU 5000 Instruction Manual - Manual (Page 38)

― 36 ―
8-2 Preparation for data transmission
(1) Power on the instrument, and get the instrument ready for a
measurement.
(Note: Data cannot be transferred while the instrument is
performing a recording.)
(2) Start up the PC software: KEW LOG Soft.
8-3 Operation of PC software
Refer to the supplied instruction manual for "KEW LOG Soft" and
transfer the data to your PC. The PC may not detect the connected
Logger or error message is displayed during data transfer, even if the
PC and the Logger are connected correctly because of static
electricity.
In this case, a message is displayed on the PC screen. Please
disconnect/ connect the USB cable once accordingly, and transfer
the data again.
8-4 Multiple connections
By using commercially available
USB hub, multiple Leak Loggers
can be connected to your PC.
With PC software "KEW LOG
Soft", the data can be
transferred to PC by selecting
one Logger from the list of
detected Logger.
You do not have to connect and
disconnect a USB cable one by
one.