KYORITSU 5000 Instruction Manual - Manual (Page 16)

― 14 ―
Step4: Start of recording
Follow the procedures stated below and start recording.
Be sure to check each setting before starting a recording since the
settings cannot be changed during a recording.
1. Press down the button for a while.
¡ At continuous recording mode or after
changing the recording mode; "CLr"
flashes while the button is being
pressed down. A few seconds later, the
measured value and the "REC" mark
are displayed on the LCD. Then a
recording starts.
(The data, which had been recorded,
will be cleared at this time. So the
important data must be transferred to
PC in advance.)
¡ At Event/ Max value/ Capture recording
mode or the recording mode is not
changed, the "REC" mark flashes and
the measured value and the "REC"
mark are displayed on the LCD. Then a
recording starts.
(At these recording modes, recorded
data will not be cleared when continuous
recording is performed. The recorded
data will be deleted when changing a
recording mode or sensor connecting
channel. So the important data must be
transferred to PC in advance.)
፧
፧
፧
፧