Spectrex 40/40L-LB UV/IR Flame Detector Series - Manual (Page 48)

SharpEye TM UV/IR Flame Detector User Guide
36 Testing Procedures
➣ To perform Fire Simulator Test:
1 Power up the system and wait up to 60 seconds for the detector to turn
to a normal state. The Power LED turns on.
2 Aim the Spectrex Fire Simulator Model 20/20-311 at the target point of
the detector (Figure 14), in a way that the radiation emitted by it is
facing directly towards the detector. (See Long Range UV/IR Fire
Simulator on page 57).
3 Press the operation button once. After few seconds, a successful test
shows the results shown in Table 17.
Table 17: Results of Successful Fire Simulator Test
Component Action Notes
0-20mA Turn to 20mA For a few seconds and then return to
4mA
Alarm Relay Activated for a few seconds and then returns to
Normal
Auxiliary Relay Activated for a few seconds and then returns to
Normal
Fault Relay Remains active
during the test
LED Red, steady
The detector is now ready for operation.