Dwyer PSX2 - Manual (Page 33)

24
7.2 Entry of site name (not required measurement)
Enter the name of the site (where measurement is
performed). This name is registered with process
setting ((4) of page 21).
(1) Move the cursor to “1: SITE MEMORY” on the
SITE SETUP screen.
Note) Before setting the “2. Establish setting”,
the Site registration is required.
(2) Press the ENT key to display the SITE MEMORY
screen.
(3) Press the ENT key after checking that cursor is
placed in the MODE.
ENT
(4) When the mode selection screen appears, move
the cursor to “REGISTRATION” and press the
ENT key.
ENT
ENT
Bulletin F-9-PUX2