Dwyer PSX2 - Manual (Page 82)

73
10.1.5 TOTALIZER: when performing the total process of measured data
(totalize)
(1) To start/set total output
[Operation]
(1) Select “TOTALIZER” on the SITE SETUP screen by
pressing the or key.
Press the ENT key to display the total output selection
screen.
Total process and setting of total output can be performed.
(3) Move the cursor to “START” by the or key,
and then press the ENT key.
The total will start.
(2) Pressing the ENT key enables you to select the total
output mode.
Select the mode from MANUAL, QUICK, and
TIMER by pressing the
or key.
(For details of MODE, refer to description of the
mode in the following page.)
(4) To stop the total output in the middle, move the cur-
sor to “STOP” and press the ENT key.
“STOP” is also possible from the totalizing calcula-
tion display button on the measurement screen.
Total will not start unless the cursor is pointed to “START”
and the
ENT key is pressed.
In timer mode, start time and date must be in the future
compared with the time and date of the system clock. To
change the system clock, refer to page 88.
CAUTION
Bulletin F-9-PUX2