Sterlco S Series Central Chilling Stations - Manual (Page 46)

Page 46 of 86 SSC Series Central Chilling Stations
• “CONFIGURATION MENU” contains the chiller setup
parameters (i.e. chiller setpoint, and high and low temperature
alarm setpoints)
The following sections in this chapter list the information you need
to navigate through these screens for operating and monitoring
your SSC Series central chilling station with the Standard Control
Package.
7-4 Viewing and Operating Chiller Compressors
Viewing Compressor Status
To view the status of the chiller compressors, start at the Main
Menu screen, then:
„ Press the
or buttons on the right side of the screen
to highlight “COMPRESSOR STATUS”
„ Press
↵
The compressor status screen displays:
Compressor Status Screen
The Compressor Status screen shows the status for compressors
within the system. Only compressors that are included in the
system will be shown on this screen. Compressors will display one
of the following states:
1. OFFLINE – This indicates that the compressor has been turned
off in the compressor enable/disable screen. The compressor
will not be called to operate until it has been re-enabled.