Brother MFC-490CW - Manual (Page 55)

Sending a Fax
39
5
Restoring all settings to the
factory settings
5
You can restore all the settings you have
changed to the factory settings. These
settings will stay until you change them again.
a
Press (Fax).
b
Press a or b to choose
Factory Reset.
Press OK.
c
Press 1 to choose Yes.
d
Press Stop/Exit.
Sending a fax manually
5
Manual transmission lets you hear the
dialing, ringing and fax-receiving tones while
sending a fax.
a
Press (Fax).
b
Load your document.
c
To listen for a dial tone press Hook or
pick up the handset of an external
telephone.
d
Dial the fax number.
e
When you hear the fax tone, press
Black Start or Color Start.
If you are using the scanner glass
press 1 to send a fax.
f
If you picked up the handset of an
external telephone, replace it.
Sending a fax at the end of a
conversation
5
At the end of a conversation you can send a
fax to the other party before you both hang
up.
a
Ask the other party to wait for fax tones
(beeps) and then to press the Start or
Send key before hanging up.
b
Press (Fax).
c
Load your document.
d
Press Black Start or Color Start.
„ If you are using the scanner glass,
press 1 to send a fax.
e
Replace the handset of the external
phone.
Out of Memory message
5
If you get an Out of Memory message
while scanning the first page of a fax, press
Stop/Exit to cancel the fax.
If you get an Out of Memory message
while scanning a subsequent page, you will
have the option to press Black Start or
Color Start to send the pages scanned so
far, or to press Stop/Exit to cancel the
operation.
Note
If you get an Out of Memory message
while faxing and you do not want to delete
your stored faxes to clear the memory,
you can send the fax in real time. (See
Real time transmission on page 37.)