HP NonStop G-Series - Manual (Page 121)

Connecting the Fibre Channel Components for the
CTL700 Tape Library
L700 (CTL700) Installation and User’s Guide — 527338-004
A- 3
Installing the SCSI Interface Cable
Figure A-2 is an illustration of where the rear components are located on the
CT9800FC Fibre Channel converter.
Figure A-2. Rear Panel Components
Installing the SCSI Interface Cable
1. Before installing the 68-pin SCSI cable from the Fibre Channel converter to the
server, make sure that the tape drive and the Fibre Channel converter are both
powered off. Refer to
Appendix B, Multimode Fiber-Optic Cables for SCSI cable
part numbers.
2. Connect the 68-pin SCSI cable to the SCSI channel port on the converter.
3. Connect the other end of the 68-pin SCSI cable to a supported SCSI port on a
NonStop S-series server.
Table A-1. Connections Supported for the CT9800FC Fibre Channel Converter
Server ServerNet/DA IOMF CRU IOMF 2 CRU PMF CRU
S7000 YES NO NO NO
S7400 YES NO YES NO
S70000 YES NO YES NO
S72000 YES NO YES NO
S74000 YES NO YES YES
S76000 YES NO YES YES
S86000 YES NO YES YES
AC Power
Receptacle
Fuse
Power
Switch
LED
Lights
SCSI Channel
Port
GBIC Input
Port
RS-232 Serial Port
(unused)