HP Color LaserJet CP6015 Printer series - Manual (Page 109)

4. Load paper into the tray face up. Check the paper to verify the guides lightly touch the stack, but
do not bend it.
NOTE: To prevent jams, do not overfill the input tray. Be sure the top of the stack is below the
tray full indicator.
NOTE: For best performance, fill the tray completely without splitting the ream of paper. Splitting
the ream can cause a multifeed problem. The capacity of the paper tray can vary. For example, if
you are using 75 g/m
2 (20 lb) paper, the tray holds a full ream of 500 sheets. If the media is heavier,
the tray will not hold a full ream. Do not overfill the tray.
NOTE: If the tray is not adjusted correctly, an error message might appear or the media might
jam.
5. Slide the tray into the product. The control panel shows the tray’s media type and size. If the
configuration is not correct, press the checkmark button
on the control panel. If the configuration
is correct, press the back arrow .
Load undetectable standard-sized paper into Trays 2, 3, 4, and 5
The following undetectable standard-sized media is supported in the 500-sheet trays:
● Executive (JIS) (8.5 x 13)
● 12 x 18 (Trays 3, 4, or 5 only)
● B4 (ISO)
● RA3 (Trays 3, 4, or 5 only)
ENWW Load paper and print media 95