HP Color LaserJet CP6015 Printer series - Manual (Page 208)

Control panel message Description Recommended action
To continue press (Checkmark
button)
PROCESSING DUPLEX JOB
Do not grab paper until job completes
Paper temporarily comes into the output bin
while printing a duplex job. Do not attempt to
remove the pages until the job is complete. Do not grab paper as it temporarily comes
into the output bin. The message will
disappear when the job is finished.
Processing... The product is currently processing a job but
is not yet picking pages. When paper motion
begins, this message will be replaced by a
message that indicates which tray the job is
being printed from. No action is necessary.
Processing... from tray <X> The product is actively processing a job from
the designated tray. No action is necessary.
Processing...copy <X> of <Y> The product is currently processing or
printing collated copies. The message
indicates that copy X of Y total copies is
currently being processed. No action is necessary.
RAM DISK DEVICE FAILURE
To clear press (Checkmark button)
The specified device has failed. Press the checkmark button to clear.
RAM DISK FILE OPERATION FAILED
To clear press (Checkmark button)
A PJL file system command attempted to
perform an illogical operation. Press the checkmark button to clear.
RAM DISK FILE SYSTEM IS FULL
To clear press (Checkmark button)
A PJL file system command could not store
something on the file system because the file
system was full. Press the checkmark button to clear.
RAM DISK IS WRITE PROTECTED
To clear press (Checkmark button)
The file system device is protected and no
new files can be written to it. Press the checkmark button to clear.
READY The product is online and ready for data. No
status or device attendance messages are
pending at the display. No action is necessary.
Ready <IP ADDRESS> The product is online and ready. No action is necessary.
Ready Diagnostics mode
To exit press STOP
The product is in Diagnostics mode. To stop Diagnostic mode, press the Stop
button.
Receiving upgrade A firmware upgrade is in progress. Do not turn the product off until the product
returns to READY.
REMOVE ALL CARTRIDGES AND DRUMS Remove image drums during component
test.
1. Open front door.
2. Remove image drums and cartridges.
3. Close the front door.
REMOVE ALL IMAGE DRUMS
TO EXIT PRESS STOP
Remove image drums during component
test. 1. Open front door.
2. Remove image drums.
3. Close the front door.
Remove or install cartridge/drum pairs This message is displayed during the Disable
Cartridge Check when the print cartridge and Remove or install cartridge and drum of the
same color together.
Table 12-1 Control-panel messages (continued)
194 Chapter 12 Solve problems ENWW