HP Color LaserJet CP6015 Printer series - Manual (Page 40)

Item Sub-item Values Description
CALIBRATE
NEUTRALS CALIBRATION SOURCE TRAY 1 <SIZE/TYPE>
TRAY 2 <SIZE/TYPE>
TRAY <X> <SIZE/
TYPE>
This menu item affects the toner mixture in order
to optimize neutral colors for color print jobs. A
special sensor measures color on three specially
printed pages from a selected tray and adjusts the
color parameters. This corrects for too much or too
little cyan, magenta, yellow, or black toner, which
improves color consistency.
Choose the source tray, paper type, and paper
size for the calibration page.
To run calibration on different paper types, load the
desired paper type in a tray, select this menu item,
and then specify the loaded tray.
CALIBRATION TYPE <TYPE> This item is available only if the selected tray type
is set to ANY TYPE.
CALIBRATION SIZE <SIZE> This item is available only if the selected tray size
is set to ANY SIZE or ANY CUSTOM.
UNIT OF MEASURE INCHES
MILLIMETERS
The unit of measure to describe a custom paper
size. This item is available only if the selected
paper size is set to CUSTOM.
X DIMENSION The X dimension of the custom paper size. This
item is available only if the selected paper size is
set to CUSTOM.
Y DIMENSION The Y dimension of the custom paper size. This
item is available only if the selected paper size is
set to CUSTOM.
AUTO CALIBRATE
NEUTRALS ON
OFF
This menu item controls whether the CALIBRATE
NEUTRALS process is performed automatically. If
you select ON, the product performs the calibration
automatically whenever environmental conditions
indicate that it is required. Three calibration pages
are printed. You can recycle these pages when the
calibration is complete.
RESOLUTION Image REt 4800
(default)
1200x600 dpi
Sets the resolution at which the product prints. The
default value is Image REt 4800. Try the
1200x600 dpi setting to improve printing for
detailed line work or small text.
EDGE CONTROL OFF
LIGHT
NORMAL (default)
MAXIMUM
The Edge Control setting determines how edges
are rendered. Edge control has two components:
adaptive halftoning and trapping. Adaptive
halftoning increases edge sharpness. Trapping
reduces the effect of color-plane misregistration by
overlapping the edges of adjacent objects slightly.
● OFF turns off both trapping and adaptive
halftoning.
● LIGHT sets trapping at a minimal level, and
adaptive halftoning is on.
26 Chapter 2 Control panel ENWW