HP Color LaserJet CP6015 Printer series - Manual (Page 250)

Understand lights on the formatter
Three LEDs on the formatter indicate that the product is functioning correctly.
1
2
1 Heartbeat LED
2 HP Jetdirect LEDs
HP Jetdirect LEDs
The embedded HP Jetdirect print server has two LEDs. The yellow LED indicates network activity, and
the green LED indicates the link status. A blinking yellow LED indicates network traffic. If the green LED
is off, a link has failed.
For link failures, check all of the network cable connections. In addition, you can try to manually configure
the link settings on the embedded print server by using the product control-panel menus.
1. Press Menu .
2. Press the down arrow to highlight CONFIGURE DEVICE, and then press the checkmark button
.
3. Press the down arrow to highlight I/O, and then press checkmark button .
4. Press the down arrow to highlight EMBEDDED JETDIRECT MENU, and then press the
checkmark button
.
5. Press the down arrow to highlight LINK SPEED, and then press the checkmark button .
6. Select the appropriate link speed, and then press the checkmark button .
Heartbeat LED
The heartbeat LED indicates that the formatter is functioning correctly. While the product is initializing
after you turn it on, the LED blinks rapidly, and then turns off. When the product has finished the
initialization sequence, the heartbeat LED pulses on and off.
If the heartbeat LED is off, the formatter might have a problem. Contact an HP-authorized service or
support provider. See the HP support flyer, or go to
www.hp.com/go/cljcp6015_firmware .
236 Chapter 12 Solve problems ENWW