HP Color LaserJet CP6015 Printer series - Manual (Page 52)

Item Sub-item Values Description
ADDRESS: Use this item to type a 32 hexadecimal
digit IPv6 node address that uses the colon
hexadecimal syntax.
DHCPV6 POLICY
● ROUTER
SPECIFIED
● ROUTER
UNAVAILABLE
● ALWAYS
ROUTER SPECIFIED: The stateful auto-configuration
method to be used by the print server is determined by
a router. The router specifies whether the print server
obtains its address, its configuration information, or
both from a DHCPv6 server.
ROUTER UNAVAILABLE: If a router is not available,
the print server should attempt to obtain its stateful
configuration from a DHCPv6 server.
ALWAYS: Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
PRIMARY DNS Use this item to specify an IPv6 address for a primary
DNS server that the print server should use.
SECONDARY DNS Use this item to specify an IPv6 address for a
secondary DNS server that the print server should use.
PROXY SERVER Specifies the proxy server to be used by embedded
applications in the product. A proxy server is typically
used by network clients for Internet access. It caches
Web pages, and provides a degree of Internet security,
for those clients.
To specify a proxy server, enter its IPv4 address or
fully-qualified domain name. The name can be up to
255 octets.
For some networks, you might need to contact your
Internet Service Provider (ISP) for the proxy server
address.
PROXY PORT Type the port number used by the proxy server for
client support. The port number identifies the port
reserved for proxy activity on your network, and can be
a value from 0 to 65535.
IPX/SPX ENABLE OFF
ON
OFF: Disable the IPX/SPX protocol.
ON*: Enable the IPX/SPX protocol.
FRAME TYPE AUTO
EN_8023
EN_II
EN_8022
EN_SNAP
Selects the frame-type setting for your network.
AUTO: Automatically sets and limits the frame type to
the first one detected.
EN_8023, EN_II, EN_8022, and EN_SNAPare frame-
type selections for Ethernet networks
APPLETALK ENABLE OFF
ON
OFF: Disable the AppleTalk protocol.
ON*: Enable the AppleTalk protocol.
DLC//LLC ENABLE OFF
ON
OFF: Disable the DLC/LLC protocol.
ON*: Enable the DLC/LLC protocol.
Table 2-1 Embedded Jetdirect and EIO <X> Jetdirect menus (continued)
38 Chapter 2 Control panel ENWW