HP Color LaserJet CP6015 Printer series User Manual
Page 173
6.
If you are adding a DIMM to slot 2, locate the hard disk release tab on the bottom of the formatter
board, and then pinch the tab to release the end of the hard disk assembly.
7.
Rotate the end of the hard disk assembly upward until you can disengage the hinge tabs at the
other end.
8.
Leaving the hard disk assembly plugged in, lay it to the side to allow space to add or replace the
DIMM in slot 2.
9.
To replace a DIMM that is currently installed in either slot, spread the latches apart on each side
of the DIMM, lift the DIMM up at an angle, and pull it out.
XO
XO
XO
XO
XO
XO
XOXOXOXOXOXO
XOXO
XOXO
XO
XOXO
XOXO
XO
XOXO
XOXO
XO
XOXO
XOXO
XO
XOXOXOXOXOXO
XOXO
XO
XO
XO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XO
XO
XO
XO
XO
XO
XOXOXOXO
XO
XO
XO
XO
XO
XO
XOXOXO
10.
Remove the new DIMM from the antistatic package. Locate the alignment notch on the bottom
edge of the DIMM.
ENWW
Replace supplies 159