Sending a test email – HP StorageWorks XP Remote Web Console Software User Manual
Page 104
8.
Repeat step 7 for all the email addresses.
To delete an email address, select the target address in the list and click Delete. You can
choose multiple addresses and delete them at once.
To change an email address, select the target address in the list and perform the same operation
for adding an address.
9.
Click Apply to apply the settings to the storage system.
Sending a Test Email
After configuring the settings for email notice, send a test email to confirm that the settings are
operating correctly.
To send a test email:
1.
Log in to Remote Web Console, and open the E-mail Information window (see
).
2.
Change to Modify mode (see
“Changing Between View Mode and Modify Mode” (page 41)
if you need instructions).
3.
Make sure that Mail Notice is set to Enable and that the settings in the window are correct.
4.
Click Test Send. A confirmation message appears.
5.
Click OK.
6.
Confirm that mail clients received the email with the reference code 7FFFFF.
An example of a test email is as follows:
Date: FRI 03 OCT 2008 10:10:10 +9000 (JST)
To: [email protected]
From: [email protected]
Reply-To: [email protected]
Subject: XP24000/XP20000 Report
Date : 03/10/2008
Time : 10:09:30
Machine : XP24000(Seq.# 11111)
RefCode : 7FFFFF
Detail: This is Test Report.
Table 30 Details on Email for SIMs Notice
Description
Item
#
Date and time when an email was sent. The mail server decides this information.
Date
1
Email address of the receiver.
To
2
Email address of the sender.
From
3
Email address to which replies from the receivers will be sent. Optional.
Reply-To
4
Email title. Cannot be changed.
Subject
5
Date when a SIM occurred.
Date
6
Time when a SIM occurred.
Time
7
Name and serial number of the storage system.
Machine
8
Reference code. The same code as reported by SNMP traps.
RefCode
9
SIM details. The same information as reported by SNMP traps.
Detail
10
See the HP XP24000/XP20000 SNMP Agent Reference Guide for reference codes and SIM details.
104 Performing Remote Web Console Operations