HP StorageWorks XP Remote Web Console Software - Manual (Page 28)

To configure a computer to use only IPv6 for communications:
1.
Select the Windows Control Panel, Network and Sharing Center, and then Manage
Network Connections.
2. Select and right-click a network that connects an SVP, and click Properties in the pop-up
menu.
3. Click Continue if the User Account Control dialog box appears.
The Networking dialog box displays properties of the selected network (see Figure 8 (page
28) ).
4. Clear the Internet Protocol Version 4 (TCP/IPv4) check box in the list.
5. Click OK to close the dialog box.
Figure 8 Networking Dialog Box for Windows Vista
•
For Solaris 10
To configure a computer to use only IPv6 for communications:
1.
Start the console.
2. Execute the following command:
ifconfig network-interface-name inet down
28 Installation Requirements and Procedures