HP Color LaserJet 4600 Printer series - Manual (Page 161)

ENWW 147
RAM DISK FILE
OPERATION FAILED
alternates with
Ready For menus press
✔
The printer received a PJL file system
command that attempted to perform
an illogical operation (for example, to
download a file to a non-existent
directory). 1. Printing may continue.
2. Turn the printer off and
then back on.
3. If the message
reappears, there may
be a problem with the
software application.
RAM DISK FILE SYSTEM
IS FULL
alternates with
Ready For menus press
✔
The printer received a PJL file system
command that attempted to store
something on the file system but was
unsuccessful because the file system
is full. Turn the printer off and
then back on to clear the
message.
This will also delete any
files saved in RAM.
RAM DISK IS WRITE
PROTECTED
alternates with
Ready For menus press
✔
The file system device is protected
and no new files can be written to it. 1. To enable writing to the
RAM disk, turn off write
protection, using HP
Web Jetadmin
software.
2. To remove this
message from the
display, turn the printer
off and then back on.
Ready For menus press
✔
The printer is online and ready for
data. No status or device attendance
messages are pending at the display. No action necessary.
Ready Diagnostics mode
To exit press Cancel
Job key The printer is online and ready for
data. No status or device attendance
messages are pending at the display. No action necessary.
Receiving upgrade A firmware upgrade is in progress. Do not turn the printer off
until the printer returns to
Ready .
REINSTALL <COLOR>
CARTRIDGE
alternates with
For help press
V
The cartridge is not fully seated. 1. Press V for detailed
information.
2. Press  and  to step
through instructions.
REMOVE ALL PRINT
CARTRIDGES To exit
press Cancel Job key The printer is executing a Component
Test and the component selected is
Belt only. Remove all print
cartridges.
REMOVE AT LEAST 1
PRINT CARTRIDGE To
exit press Cancel Job
key The printer is executing a Disable
Cartridge Check or Component Test
where the component selected is
Cartridge Motor. Remove one print
cartridge.
Message Description Action