HP Color LaserJet 4600 Printer series - Manual (Page 229)

ENWW 215
8 Holding the DIMM by the edges,
align the notches on the DIMM with
the bars in the DIMM slot.
Note If you have difficulty inserting the
DIMM or closing the latches, make sure
the notches on the bottom of the DIMM
are aligned with the bars in the slot. If the
DIMM still does not go in, make sure you
are using the correct type of DIMM.
9 Firmly press the DIMM straight into
the slot. Close the locks on each
side of the DIMM until they snap
into place.
10 Align the formatter board in the
tracks at the top and bottom of the
slot, and slide the board back into
the printer. Replace and tighten the
eight screws removed in step 2.
11 Reconnect the power cable and
interface cables, and turn the printer
on.
12 If you installed a memory DIMM, go
to
Enabling memory . If you installed
a language font DIMM, go to
Enabling the language font DIMM .
1 8
1 9
10
11