Boonton PIM 31 User Manual - Manual (Page 10)

10
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
Do not substitute parts or perform any unauthorized modification of the
instrument. Return the instrument to Boonton Electronics for repair to
insure that the warranty and safety features are maintained.
NON IONIZING RADIO FREQUENCY RADIATION HAZARD
This device generates Radio Frequency (RF) energy under normal
operation, and should always be operated in accordance with local and
national licensing laws. RF energy in the 700 to 1,000 MHz and 1,800 to
2,200 MHz with a total power of up to 50W Watts or +47 dBm is present
at the test port during testing. The Test Port is to be terminated into a
non radiating 50 ohm load to reduce the risk of RF exposure. Do not
switch RF Power On if Test Port is open or load is unknown.
ELECTRIC SHOCK HAZARD
The device is supplied with 90 to 264 Volt AC. Prior to AC connection
always inspect the power cord and instrument case for damage. If
damage is observed, do not use until inspected and repaired by an
authorized Boonton Service center.
2.2 DISCLAIMER
PIM 31 test systems transmit two settable CW RF signals, with a power of up to
25W each, to measure passive intermodulation of components and transmitting
systems.
Wireless Telecom Group and its subsidiaries are under no circumstances
accountable for use of PIM31 test systems not conforming to laws and
regulations of national and local authorities. Customer / user bear the full
responsibility and legal accountability to use PIM31 only in a lawful manner.