Boonton PIM 31 User Manual - Manual (Page 42)

42
Content (comma separated)
Variable
Format
Description
Date YYYYMMDD
Time HHMMSS
PIM (dBc) -XXX.X Signed Field
PIM (dBm) -XXX.X Signed Field
RSSI (dBm) -XXX.X Signed Field
F1 (MHz) XXXX.X Frequency 1 in MHz
F2 (MHz) XXXX.X Frequency 2 in MHz
IM 3 (MHz) XXXX.X IM3 Frequency in MHz
F1 (dBm) XX.X F1 Power level in dBm
F2 (dBm) XX.X F1 Power Level in dBm
IM3 Bandwidth (Hz) XXXXX IM 3 Bandwidth in Hz
PIM 31 Type XXX Example: “F03”
Model String - 40 Characters max
Serial Number String - 40 Characters max Serial number of test system
HW Version String - 40 Characters max Hardware version
SW Version String - 40 Characters max Software version installed
OS Version String - 40 Characters max Operating system
Carrier String - 70 Characters max Carrier name
Site Name String - 70 Characters max Site / Test description
Feeder String - 40 Characters max Feeder description
User String - 70 Characters max User name / Initials
“Wireless Telecom Group” String For internal use
“PIM 31 Data Log” String For internal use
Cal date YYYYMMDD Date of Last Calibration
CHKSUM XXX For future use
Added with firmware version 1.2 and later.
SECTOR String - 40 Characters max Sector description.
BarGraph_RG -XXX Value of Bar Graph green /red
threshold (–dBc).
RFON String:
RF On time in seconds,
1m,2m,5m,10m,20m,30m,60m,
120m,180m or “Always On”
RECINTRV String Lists Recording interval time
and units or “OFF”
ALC String - 3 Characters max “ON” or “OFF”