High Country Tek epc, Electronic Pump Controller - A Multi-Function SAE J1939 Compatible Module - Manual (Page 24)

023-00354-Rev1.6 evc/epc User Manual 24
Copyright © High Country Tek, Inc. – 2013
evc/epc Controller
With SAE J1939 Interface
Pulse/AIN 2 Settings
Pulse Input Selections (Analog or Pulse) – Select
analog to use this input as analog input 2 for dual
valve control or select pulse to use this input as the
pulse input for anti-stall function.
0-5V, 0-10V & ±1V (Enabled/OFF) – Select the
voltage range that matches the analog input signal.
The ±1V only applied to Pulse input.
For anti-stall function, match the voltage range to
the Pulse Pick UP. The signal can be 0-5VDC, or
0-10VDC, or ±1VDC.
Pulses per revolution PPR - (1 to 65535) – Enter
the pulse per revolution of the speed sensor.
Maximum displayed RPM (1 to 65535) – Visual only - scales the RPM gauge on the Dashboard.
Keep this value near the maximum RPM to assure the resolution and accuracy.
RPM slow Set-Point or Max Load RPM (1 to 65535) – The set-point where coil A current starts to reduce in Anti-
Stall or HP limit modes.
RPM stop Set-Point or No Load RPM (1 to 65535) – The set-point where coil A current reaches 0 in Anti-Stall or
HP limit modes. If auto-reverse is ON, reverse cycle will start at this rpm.