High Country Tek epc, Electronic Pump Controller - A Multi-Function SAE J1939 Compatible Module - Manual (Page 5)

023-00354-Rev1.6 evc/epc User Manual 5
Copyright © High Country Tek, Inc. – 2013
evc/epc Controller
With SAE J1939 Interface
Controller Specification
48.5mm
125mm
5
8
m
m
4 3
9 10 11 12
2 1 6 5
7 8
114mm
CL
2x Ø5
Controller Mounting Information

Mount controller in an easily accessible
location.

Mount controller to a flat, cool surface.

If mounting to a hydraulic product, allow at
least a 2mm air gap underneath the unit.

Use BOTH mounting holes with correct
hardware.

DO NOT mount controller with connector
facing UP if possible.
Housing Type HCT encapsulated block
Power Supply Voltage 9 to 32VDC (Absolute maximum)
Current Consumption Valve current + 50mA Quiescent (Max)
Command Inputs SAE J1939
2x switched inputs (ON/Off)
2x analog inputs:
One with
(0-5V, 0-10V, 4-20mA)
One with (0-5V, 0-10V, Pulse or Freq. - 3 to
30KHz)
Input Impedance Voltage & Freq. inputs = 100k

4-20mA input = 100

Outputs 2x 3A proportional PWM (Sourcing)
( Short circuit protection and open circuit alert )
1x 5VDC ±10% (Regulated voltage @ 250mA)
PWM Dither Freq. Software adjustable - 33 to 500Hz
Module Connector DTF15-12PB, 12-way Male
Communication Mini-B USB standard
Housing Material Black, Polycarbonate
Encapsulation Flameproof epoxy resin
Mounting 2x No.8 (5mm) screws
Temperature Range -40 to +85ºC (Operational)
-60 to +90ºC (Storage)
NEMA/IP Rating NEMA 6P/IP67