Chatsworth Products Hot Aisle Containment - Manual (Page 36)

BTS Aisle Containment Manual, Rev. 1.0 ___ December 2013
Chatsworth Products 36
DOOR FRAME ASSEMBLY
REMOVING THE RAIL COVER
Lay the rail assembly on the floor; use packaging to protect finish. Remove the four nuts
that hold the cover on the rail and remove the cover. Set the cover aside.
ASSEMBLING THE DOOR FRAME
Position the rail assembly with the front towards the floor. Attach the side panels to the rail
assembly using M6 flange nuts (see first picture on following page). The rail has bolts that
protrude out of the back of the rail; these bolts go through the holes in the top flange of the
panels. Be sure that the angles on the front face of the panels are positioned towards the
center of the door opening (see second picture on following page). To ensure that the
panels are mounted square to the rail be sure that the top edge of the panels are butted
against the rail extrusion and slide the panels so that they butt against the rail end plates
(see detail on page 13).