Chatsworth Products Hot Aisle Containment - Manual (Page 51)

BTS Aisle Containment Manual, Rev. 1.0 ___ December 2013
Chatsworth Products 51
ADJUSTING DOOR ALIGNMENT
Q: What if there is an uneven gap between the two door assemblies?
A: Either one of both of the door assemblies is not level. Adjust the leveling nuts to
level the doors and eliminate the gap.
Q: What if the door vertical gasket stops before sealing to the vertical L shaped
bracket on the side assemblies?
A: The door(s) are not centered on the track. Loosen hardware securing door support
brackets to the trolley system. Slide door assemblies left or right as required. Re-
tighten hardware.
Q: What if the door stops before fully closing?
A: Adjust door brush seal height if too low. Door support hardware may be
overtightened. Loosen M8 hardware securing door to support brackets. Loosen
leveling nuts to lower door assembly. Check operation. If improved, tighted the M8
nuts attaching the door assembly to the bracket finger tight then ¼ turn with a wrench.