Chatsworth Products Hot Aisle Containment - Manual (Page 7)

BTS Aisle Containment Manual, Rev. 1.0 ___ December 2013
Chatsworth Products 7
UNPACKING
The containment system components are packaged in separate crates. Inspect the
components for damage as they are unpacked. If any damage is observed, contact your
distributor or CPI Customer Service.
CAUTION: Aisle containment components are heavy. Use a
minimum of two (2) people to unpack and remove components from
the pallet.
1. Components are packaged in protective crates. The upper crate will need to be
removed to access the components. Carefully remove the mounting screws from the
steel plates that tie the upper and lower crate. The upper crate will need to be lifted
and set aside.
CAUTION: The upper crate is heavy. Use a minimum of two (2)
people to remove.
2. Individual component pieces will be individually wrapped with foam. The foam
should be used to provide protection when the components are staged on the floor
prior to assembly. Use a utility knife to cut any tape. Be careful not to allow the knife
to contact the components as this causes damage.
RECYCLABLE MATERIALS: CPI uses only recyclable materials in all
of its containment packaging. Please save packaging for later use or
dispose of properly. All wood components of CPI pallets have been
properly treated to comply with the pest-free certifications required by
foreign countries.
3. After the all of the components have been unpacked, locate the hardware kit and
inspect the product for concealed damage. If any damage to the aisle containment
solution is observed, contact your distributor or CPI Customer Service.