Asus TS300-PA4 - Manual (Page 131)

ASUS TS300-E3/PA4 & PS4 6-3
6.1.2 Installing hard disk drives
The motherboard supports Serial ATA (both models) and SCSI hard disk drives
(P5MT-S model only) for RAID set configuration. For optimal performance, install
identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for RAID configuration:
1. Install the SATA hard disks into the drive bays following the instructions in the
system user guide.
2. Connect a SATA signal cable to the signal connector at the back of each drive
and to the SATA connector on the motherboard.
3. Connect a SATA power cable to the power connector on each drive.
To install the SCSI hard disks for RAID configuration:
1. Install the SCSI hard disks into the drive bays following the instructions in the
system user guide.
2. Connect the SCSI interface cable connectors at the back of the SCSI drives.
3. Connect the other end of the SCSI interface cable to the SCSI connector on
the motherboard.
6.1.3 Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set
from SATA hard disk drives attached to the SATA connectors supported by the
Intel ® ICH7R Southbridge chip. To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Main Menu, select IDE Configuration, then press <Enter>.
3. Set the ATA/IDE Configuration item to [Enhanced Mode], then press
<Enter>.
4. Set the Configure SATA As item to [RAID].
5. Save your changes, then exit the BIOS Setup.
Refer to Chapter 5 for details on entering and navigating through the BIOS
Setup.