Asus TS300-PA4 - Manual (Page 50)

Chapter 2: Hardware setup 2-30
2.10.1 Chassis fan
To remove the chassis fan:
1. Unplug the chassis fan cable fron
the REAR_FAN1 connector on the
motherboard.
2.10 Removable components
You may need to remove previously installed system components when installing
or removing system devices, or when you need to replace defective components.
This section tells how to remove the following components:
2. Locate the four screws that secure
the fan to the chassis.
3. Remove the four screws while
carefully supporting the chassis fan
with your free hand to prevent it
from falling off.
Set the screws aside.
4. Carefully remove the chassis fan.
1. Chassis fan
2. HDD blowers
3. SATA/SCSI backplanes
4. Floppy disk drive module 5. Front I/O board
6. Chassis footpads and roller
wheels
7. Power supply unit