Asante Technologies Voyager II - Manual (Page 43)

Slow shutter: The higher value correspond the slower shutter and the video will clear in dark
place, but frame rate will drop.
Flicker Control: The screen flickers under fluorescent lamps when the lens is at 50Hz in the
NTSC mode or 60Hz in the PAL mode. Activate this function to reduce flickers.
Basic Setting > Audio
Basic Setting > Audio >Device Audio Setting
Audio: Full duplex, half duplex, simplex microphone only, simplex amplifier only, and audio
off.
Full duplex: Allows using a microphone and amplifier at the same time, or turning them off.
Half duplex: Allows using a microphone or amplifier by manual switch.
Simplex microphone only: Allows using the microphone only.
Simplex amplifier only: Allows using the speaker only.
Audio off: Turns audio off; i.e. both the microphone and speaker are off.
Audio input: 1 formats
Audio output: 1 formats
G726/24: Uses G.726 24Kbps for audio encryption/decryption.
Gain: Adjust the volume of the audio.
Basic Setting > User(User)
The administration of the camera can set up access privileges by administrator, operator, and
viewer to ensure the security and control of the camera. The access privileges and setting
steps are described as below.
Basic Setting > User > User List (access privilege list)
The access privileges of the administrator, operator, and viewer are listed as follows. The
Audio transfer mode
Audio encryption format
43