Asante Technologies Voyager II - Manual (Page 47)

Network setting page
DHCP setting:
DHCP (Dynamic Host Configuration Protocol) is a protocol that enables automatic
assignment of TCP/IP information to the client. Each DHCP client connects to the DHCP
server to access its network setting information, including IP address, gateway, and DNS
server.
The IP address of the camera is 192.168.0.20 by default when DHCP is "OFF". When you
select "DHCP ON" and access the DHCP network environment, the camera will
automatically send a DHCP packet to request an IP address. This IP address is assigned
automatically from the DHCP server on the network. No additional settings are required for
this page unless you need to change the network configuration. The DHCP status of the
camera is "OFF" by default.
Other settings:
For IP address, Subnet mask, Default gateway, DNS 1, and DNS 2, the DHCP server will
assign these values automatically when DHCP is in "ON" status; otherwise, you need to key
in the values manually.
Note: Where no IP address is assigned from the DHCP server, the system will set the
Link-Local Address automatically.
47