Asante Technologies Voyager II - Manual (Page 56)

Note: Refer to the user setting instructions of your wireless IP access point for more
information.
Ex.: Wireless mode setting (applicable to most situations)
Selection:
1. Mode: Select Infrastructure to connect the camera to a wireless base station.
2. Authentication Type: Select Shared Key.
3. SSID: Enter the server name of the base station.
4. WEP Encryption: Select the encrypted key that is the same as the base station.
5. KEY: Select a group that is the same as the wireless base station. You must select KEY1
for base stations that only have a set of keys.
6. DHCP ON/OFF: DHCP ON is recommended.
7. Save the settings.
8. Restart the equipment.
„ Basic Setting > Network > Wireless Setting> Wireless IP Assignment (IP setting in
the wireless networking mode)
DHCP setting:
DHCP (Dynamic Host Configuration Protocol) is a protocol that enables automatic
assignment of TCP/IP information to the client. Each DHCP client connects to the DHCP
server to access its network setting information, including IP address, gateway, and DNS
server.
The IP address of the camera is 192.168.0.20 by default when DHCP is “OFF”. When
you select “DHCP ON” and access to the DHCP network environment, the camera will
automatically send a DHCP packet request an IP address. This IP address is assigned
automatically from the DHCP server on the network. No additional settings are required
for this page unless you need to change the network configuration. The DHCP status of
the camera is “OFF” by default.
Other settings:
For IP address, Subnet mask, Default gateway, DNS 1, and DNS 2, the DHCP server will
assign these values automatically when DHCP is in "ON" status; otherwise, you need to
key in the values manually.
56