Asante Technologies Voyager II - Manual (Page 58)

Streaming port setting
Basic Setting > Network > PPPoE (dial-up networking setting)
PPPoE: Point to Point Protocol over Ethernet is applicable to networking via a xDSL or
cable modem. PPPoE setting must be executed in the LAN environment for your PC to
connect to ADSL. Follow the steps below to complete the setting:
1. Dial: You can select whether or not to dial when you boot the machine.
2. Use DHCP or fixed IP for connection to the LAN environment.
3. Key in the IP address of the camera and enter "PPPoE Setting" following the route
Setting Î Basic Setting Î NetworkÎ PPPoE.
4. Key in the xDSL "Username" and "Password" acquired from your ISP. Click Save
to confirm the setting.
5. Where the ADSL modem and the camera is connected via a switch-hub, you can
press “Reboot” or restart the machine manually to try PPPoE dialing when the setting
of the camera has been completed.
6. A different IP address is obtained after each dial-up network connection. You can get
the new IP address from Setting Î Basic Settings Î System. If you want to know the
new IP address anytime, you must enter Setting Î Basic Settings Î Notification to set
some settings. There are three ways to get information: 1. SMTP 2. FTP 3. HTTP. For
details, refer to the Notification Setup Menu.
Note: You can use the DDNS function to access the camera. Refer to the “DDNS Setting”
page for more information.
58