Asante Technologies Voyager II - Manual (Page 75)

(Please refer to Attachment A for detailed explanation.)
Note: It is recommended to set up the Trigger Setting page (Setting-> Application Setting->
Event-> Trigger) before install the hardware alarm I/O!
Trigger Alarm output: Alarm output
Click “Set” to trigger the alarm. Click “Clear” to stop the alarm. (Please make sure to click
“Clear” for close the alarm testing when the trigger testing is done).
Trigger mail: Sending mail
Click “Set” after you enter the email address and subject to test the integrity of the sent mail.
Trigger FTP: Sending AVI file to FTP Server
Upload AVI files to FTP server to test the file integrity.
HTTP Server: Sending message to HTTP Server
Upload message to HTTP server to test the message integrity. Enter the message in the
“Message” field. You may go to Application Setting > Event > Event Server to make a
complete custom parameters settings.
TCP Server: Sending message to TCP Server
Enter the message in the “Message” field.
Trigger SAMBA: Sending message to Samba shared folder
Path: Enter the path of the shared folder in your PC.
Application Setting > Event > Event Servers (setting for uploading trigger
event file to the server)
Here you can perform a complete setting for uploading files to the server. Please set servers
(SMTP, FTP, SAMBA…etc) in the Event Server setting by the instructions below:
75