Panasonic WJ-NV200 - - Manual (Page 42)

42
[Daylight saving time table]
Set the start (In)/end (Out) time and date of daylight saving
time.
Clicking the [Setup >] button will open the "Daylight saving
time table" window.
Enter the start (In) and end (Out) date and time for daylight
saving time.
The calendar will be displayed by clicking the [
] icon.
Refer to the instructions "Configure the minimum settings"
(☞ page 38) for how to perform the setting.
Up to 10 times and dates can be set for the changeover to
daylight saving time.
To delete the set times and dates for switching to daylight
saving time, select the number to be deleted from "Table to
delete", and click the [Delete] button.
To return to the previous page, click the [Back] button.
Important:
• Setting is impossible when the interval between start (In)/
end (Out) is less than an hour.
[Auto time adjustment]
Select a method of auto clock adjustment from the following.
Off: Does not adjust time automatically.
On: Receives a signal from the ALARM/CONTROL con-
nector on the rear panel of the recorder and adjusts
the clock. When the signal is received and if the
clock is within 29 minutes ± the hour, the time will be
adjusted to 00 minutes 00 seconds.
Default: Off
[Date & time settings] tab
Perform settings such as date & time format, time zone, daylight saving time, and time adjustment method.
■ Display format
Set the current date and time.
[Date]
Select a date/time display format. (Example: April 1, 2010)
yyyy/mm/dd: 2010/04/01
Mmm/dd/yyyy: Apr/01/2010
dd/Mmm/yyyy: 01/Apr/2010
mm/dd/yyyy: 04/01/2010
dd/mm/yyyy: 01/04/2010
Default: yyyy/mm/dd
* Depending on the location, only the last 2 digits of the
year will be displayed.
[Time]
Select a time display format. (Example: 3 o'clock in the after-
noon)
24 h: 15:00:00
12 h: 03:00:00 PM
Default: 12 h (WJ-NV200K)
24 h (WJ-NV200K/G)
■ Time zone
Select the time zone and shift to/from daylight saving time.
[Set time zone]
Select your time zone.
GMT-12:00 - GMT+13:00
Default: GMT-5:00 (WJ-NV200K)
GMT (WJ-NV200K/G)
[Daylight saving time]
Determine how to switch to/from daylight saving time.
The asterisk "*" will be displayed before time and date during
daylight saving time.
Out: No changeover to daylight saving time.
Auto: Automatic changeover to daylight saving time
according to the daylight saving time changeover
settings.
Default: Auto