Panasonic WJ-NV200 - - Manual (Page 49)

49
Set up VMD alarm [VMD alarm]
Select the VMD function for each camera and transmit the information to the cameras to change the camera settings.
Clicking the [Setup >] button for "VMD alarm" on the [Camera setup] tab will display the following items.
[VMD alarm]
Select whether or not to use the VMD (VMD: Video Motion
Detector) alarm function when a change (movement) is
detected in the image. Refer to the operating instructions of
the camera in use for how to configure the VMD alarm.
On: Detects alarms.
Off: Does not detect alarms.
Default: On
Important:
• When the setting to change the image refresh interval is
transmitted to a camera, the image transmission from
the camera is temporarily interrupted and recording is
unavailable during this period.
■ Camera selection
Select the camera to which the VMD alarm setting is to be
sent. Mark the checkbox of the camera to transmit to.
[Transmission] button
Transmit the VMD settings to the camera.
Once transmission is completed and the setting has been
applied to the camera, "OK" will be displayed under
"Results". If the display reads "Authentication error", etc., the
camera connection or the setting may have failed.
[Back] button
Click this button after completing the settings. The screen
returns to the [Camera setup] tab.