Panasonic WJ-NV200 - - Manual (Page 64)

64
Configure the Panasonic alarm protocol settings [Panasonic alarm pro-
tocol]
The settings to notify the PC of the event and error information when an event or an error occurs can be configured on this tab.
To display the event and error information, it is necessary that the dedicated software is installed on the PC.
Refer to the "readme.txt" on the provided CD-ROM for details on the software.
[Port number(to PC)]
Enter the addresses of the recipient PCs.
It is usually not necessary change the default.
Default: 1818
[Retry]
Set the number of retry attempts for the transmission to the
PC.
0 - 8 (times) (In steps of times)
Default: 2
Note:
• If the transmission to the PC fails, increase the number
of retry attempts.
[Destination address - Address1 - Address4]
Enter the addresses of the recipient PCs. Enter the IP
address or host name for "Address1" - "Address8". The host
name is available only when "Auto" is selected for "DNS" on
the [Basic] tab accessed from the "Advanced setup" menu -
the "Network" page of the setup menu.
Up to 8 destination addresses can be registered.
Enter up to 255 alphanumeric characters including hyphens
(-) and periods (.).