Revolabs FLX2 VoIP Advanced - Manual (Page 24)

24
NOTE: An incoming Bluetooth call will display caller ID
information as well if it is presented by the network.
Muting a Call
1. In handset mode, the ‘Mute’ and ‘UnMute’ key will
mute/unmute the FLX Dialer microphone, not the
wireless Microphones.
2. In speaker mode, the ‘Mute’ and ‘UnMute’ key will
mute/unmute all wireless Microphones.
NOTE: If the setting ‘All Mic Mute’ is OFF, the Microphone
mute buttons will be locked while the Master Mute is active. The
Master Mute can only be deactivated via the FLX Dialer. Once
deactivated, the Microphones will return to their previous mute
state. If ‘All Mic Mute’ is ON, the Mute / UnMute button on the
FLX Dialer and the mute buttons on the FLX Microphones work
together. Pressing either of these buttons will mute / unmute all
microphones out of the Charger Base, or in the Charger Base if
no microphone is outside.
Active Call Menu
During a call, pressing the ‘Enter’ key will open the ‘Active
Call Menu’. This menu allows putting a caller on hold, start
a Conference call based on a dialed number, a contact, or a
recent call. This menu also allows transferring an active call
to another number. It also provides access to the Device
Status menu (see page 40), Audio Controls (see page 39)
and the System Info menu (see page 41).
Placing a Call on Hold
1. Access the Active Call Menu by pressing the ‘Enter’
key during a call. Select menu item ‘Hold’. An
orange phone symbol represents a call on hold.
2. To resume the call press the ‘Resume’ key.