Revolabs FLX2 VoIP Advanced - Manual (Page 52)

52
Web Interface
The FLX web interface provides access to advanced configuration settings, call
statistics and system logs. Web access can be enabled or disabled from the FLX
Handset, and the web interface is password protected using the same password that is
required to access Administrator settings on the FLX Handset.
This section describes the web interface, organized as follows:
• Enabling Web Access
• Connecting to the FLX Web Interface
• Home Page
• User Settings
• Administrator Settings
The Administrator Settings section also describes how FLX configuration settings can
be imported and exported to aid in configuring multiple FLX phones in an enterprise.
Enabling Web Access
To enable the web interface, from the FLX Handset select Menu > Setup > Advanced
Setup, enter the administrator password, then select Admin Settings > Web Access
ON/OFF. Press the Enter button to toggle between ON and OFF to control access.
Factory default is web access enabled. To change the password needed to access both
the web interface and advanced settings on the Handset, see the Set Password section
on page 46. The web interface also includes a web session timeout to protect against
unwanted access if the session is left open for more than fifteen minutes.
Connecting to the FLX Web Interface
To use the web interface, open a web browser and navigate to the IP address of the
FLX. If you do not know the IP address of your FLX system, on the handset open the
menu, System Info, About System. The IP address is listed here. The Login page will
appear as shown below.