Revolabs FLX2 VoIP Advanced - Manual (Page 7)

7
Quick setup for VoIP Conference Calls
While all components delivered with the Revolabs FLX2 Conference Phone are partially
charged, we recommend charging the Speaker, the Microphones, and the Dialer for at
least 8 hours or overnight before starting to use the system.
Connecting the Base Station
Place the Base Station close to the Ethernet outlet
you want to use for the conference phone.
Connect the Base Station to the network using the
provided Ethernet cable. The Base Station is
powered using Power over Ethernet (PoE). If the
base station does not power up after you connect
it to the network outlet, this outlet might not be
providing PoE. Please check with your IT
department that PoE is available.
If your network does not support PoE, Revolabs
provides a power injector that can be bought
through your reseller, which adds the necessary
power to that Ethernet connection.
Connecting the Charger Base
Place the Charger Base at a location where you
can easily access the Microphones and the
Speaker for your conference calls, e.g. on a side
board, a desk, or the conference table. Connect
the Charger Base to a power outlet using the
provided power supply. Place the Speaker, the
Microphones, and the Dialer in the respective
openings of the Charger Base to charge them.
The Dialer and Speaker will automatically connect
to the Base Station after a short time if it is
powered up. You will hear a confirmation chime
from the Speaker once the system is ready for
use. If the Speaker or the Dialer is not powered
up, take them out of the Charger Base for a few
seconds and put them back in. This will switch on
the component.
To switch on the microphones
take them out of the charger
base. They will automatically
power up and connect to the
base station.