Revolabs FLX2 VoIP Advanced - Manual (Page 48)

48
Speaker
1. To pair a Speaker first turn it off by pressing and holding the button on the bottom
of the Speaker until you hear the Speaker shut-off or the LEDs turn off.
2. Ensure that the Base Station is plugged in and powered up.
3. On the Dialer, browse to the Pairing menu: Menu
Setup Advanced Setup
Pairing.
4. Select SPK 1 (Speaker 1) and press the ‘Enter’ or ‘Pair’ key to enter pairing
state.
5. The screen will display ‘Pairing Speaker 1’.
6. Press and hold the button on the bottom of the Speaker until the LED turns solid
red. The speaker is now in pairing mode.
7. After a short time an overlay will appear on the FLX Dialer saying ‘Pairing
Successful’, after which the screen should read ‘SPK 1 Linked’.
8. If pairing was unsuccessful, the Speaker will show an alternating red -green slow
blinking sequence indicating that the pairing failed. The Dialer will display a
‘Pairing Timeout’ message. In that case the pairing procedure should be
repeated.
Microphone
1. To pair a Microphone, turn off the Microphone by holding the mute button until
the LED turns red if it is not already turned off.
2. Ensure that the Base Station is plugged in and powered up.
3. On the Dialer, browse to the Pairing menu: Menu
Setup Advanced Setup
Pairing.
4. Select MIC 1 (Microphone 1) or MIC 2 (Microphone 2) and press the ‘Enter’ key
to enter pairing state.
5. The screen will display ‘Pairing Mic 1’ or ‘Pairing Mic 2’ depending on which
Microphone you are pairing.
6. Press the mute button on the Microphone and hold it until the LED turns solid
red. The Microphone is now in pairing mode.
7. After a short time an overlay will appear on the Dialer ‘Pairing Successful’, after
that the screen should read ‘MIC 1 Linked’ or ‘MIC 2 Linked’, based on which one
you were pairing.
9. If pairing was unsuccessful, the Microphone will show an alternating red - green
slow blink sequence, indicating that the pairing failed. The Dialer will display a
‘Pairing Timeout’ message. In that case the pairing procedure should be
repeated.
LED Pairing Indicators:
Speaker Indicator Status
Steady Red Speaker is in Pairing Mode, either waiting or pairing in progress
Slow red- green flash Pairing failed or timed out
Green flash Pairing successful
Microphone Indicator Status
Steady Red Pairing Mode, either waiting or pairing in progress
Slow red – green flash Pairing failed or timed out