Revolabs FLX2 VoIP Advanced - Manual (Page 47)

47
Recent Calls ON / OFF
The Recent Calls option allows you to enable or disable logging of the recent calls. If
you switch Recent Calls OFF the list of the recent calls will be erased and no future
information on recent calls will be kept in the system.
Web Access ON / OFF
Web Access OFF allows you to disable the web interface into the FLX. If Web Access
is set to off, any attempt to open the web interface will be declined. Please be aware
that if the web interface is switched off, it can only be restarted from the phone.
Pairing
All FLX2 wireless components are paired before the system
is shipped, providing much of the system setup already
completed. While pairing should not be required for the
system to work, sometimes components can require pairing if
a part is shipped separately.
The following are instructions on how to pair the wireless
components of the system to the FLX2 Conference Phone.
All components are paired to the Base, which is the central
unit that communicates with all other components. To pair a
Microphone or a Speaker to the FLX Conference Phone, a
FLX Dialer has to be paired first. If several components
need to be paired, or a whole system needs to be paired,
start with the FLX Dialer.
Dialer
1. Turn off the Dialer by pressing and holding the red ‘end call’ button until an
overlay appears asking whether you want to shut the Dialer down. Press ‘Yes’.
2. Plug in the FLX2 Base Station.
3. Turn the Dialer back on (press the red ‘end call’ key). The screen should read
“Scanning for new base”. If the screen reads “scanning for paired base”, press
the ‘Stop’ button, press the ‘Menu’ button, navigate to “Advanced’, and select
‘Re-Pair’. When asked whether to ‘Scan for New Base’, select ‘Yes’.
4. After some time scanning for available bases, an overlay will appear asking ‘Pair
with <System Name>?’ The system name is either the Factory preset name of
RevoFlxxxx, with xxxx the last 4 digits of the BT number on the bottom of the
Base station, or the system name you previously selected in the Advanced
Setup. Select ‘Yes’.
5. An overlay, ’Pairing with base <System Name>’, should appear followed by a
‘Connecting…’ and then an ‘Initializing…’ screen. Shortly after that the Dialer
home screen will appear. Your Dialer is now paired.
6. If the Dialer does not automatically pair, repeat steps 1-5. If this still does not
resolve the problem, select “Reset Factory Defaults” under ‘Advanced’ as this will
force a scan for a new base.
SPK1 Linked
Return Pair
MIC1-W Paired
MIC2-O Linked
SETUP
SPK2
Device Pairing