Revolabs FLX2 VoIP Advanced - Manual (Page 85)

85
Device LED Indicator Status
o Connected, battery low, call in progress, Master
Mute or “All Mic Mute” is ON, all Microphones
muted
Flashing Yellow* – Red – Yellow* –
Green
Searching for a connection to the base
The speaker will try to re-establish the link
for about 10 minutes, then power off.
Alternating slow Red - Green flash
Speaker is not paired to a Base Station
The speaker will power down after two minutes.
Steady Red
o Speaker is being powered down
o Speaker is in pairing mode.
Groups of five rapid Red flashes Speaker is in a fault condition.
Device LED Indicator Status
Base Station
Long solid on, then a long solid off Power On Boot Process
Double flashes every second
Operating Mode indicating that Base Station is
functional.
Skip every fifth double flash
Fault indication. This also indicates past faults that
have no bearings on current operation
Continuous Fast Flashing
Updating non-volatile memory as part of software
update
Off No Power
* In some Speakers the LED Indicator color Yellow might look like Red.
Reset to Factory Defaults
See page 41 for a description on how to reset the FLX2 Conference Phone back to its
factory defaults.
Technical Specifications
Models
The Revolabs FLX2 VoIP System is available with a variety of configurations to provide
the best audio capture in the industry. The following is a list of the available models. All
of these models are SIP enabled and require an IP connection.
10-FLX2-200-VOIP
FLX2 System w/ 2 Omni Microphones
10-FLX2-101-VOIP FLX2 System w/ 1 Omni & 1 Wearable Microphone
10-FLX2-002-VOIP FLX2 System w/ 2 Wearable Microphones
10-FLX2-020-VOIP FLX2 System w/ 2 Directional Microphones
10-FLX2-200-DUAL-VOIP FLX2 System w/ 2 Omni Microphones and 2 Speakers