Konica Minolta bizhub PRESS C8000e User Manual
Page 182
5.3
Both Sides Adjust
5
bizhub PRESS C8000/e
5-42
7
Using a scale, measure the length of lines for each point from [1] to [8] printed on the chart.
% The figure below shows an example where the lines [1] and [5] are measured. Similarly, measure the
length for all points.
% Measure down to 0.1 mm so that you can make an adjustment in that increments.
% Be sure to make note of the measured length.
8
Press the number key provided for each point, and then enter the measured length using the touch pan-
el keypad or control panel keypad.
% You can change the value by pressing [,] and [+].
% Press [Clear] to reset the entered value to [0].
9
When completing the entry, press [Adjustment Start].
% If you do not start the adjustment, press [Close].
% Pressing either [Adjustment Start] or [Close] clears the entered value to [0.0].
The Both Sides Adjust Screen will be restored.